FAQ - OMNI Readers
- 1 1. How do I connect the scanner to the host computer?
- 2 2. How do I verify that the reader works?
- 3 3. How do I know what interface type is on my Omni Reader?
- 4 4. After programming the reader, my Omni reader gives multiple quick beeps when reading a card, but there is no data output, why is this?
- 5 5. What software should I use to program the Omni Reader?
- 6 6. What command I should use to reset the Omni to the factory default settings?
- 7 7. My Omni keyboard interface reader works with an external keyboard attached, but it will not work when I remove the keyboard. Is there a way to make it work without having to connect an external keyboard?
- 8 8. How do I know if the code is being taken correctly by the reader while programming the Omni reader? What else do I need to know when programming the reader through keyboard entry?
- 9 9. How do I make the cursor stop at the end of the barcode data (no Enter needed)?
- 10 10. How do I make the reader do a Tab instead of the Enter at the end of barcode data?
- 11 11. It takes several swipes to get a good barcode read after the card has been laminated, why is this?
- 12 12. How do I get rid of the Enter in between track 1 and track 2 of the magnetic data output?
- 13 13. How do I program the reader so that it will not output the start & end sentinels from the magnetic card?
- 14 14. How do I program the Omni to output only the data from track 2 of a magnetic card?
- 15 15. I have a USB/KB interface Omni Reader (WCR3237-xxxU or WCR3237-x00US), where do I find the driver?
- 16 16. I have a USB/RS232 interface Omni Reader (WCR3227-xxxU or WCR3227-x00US), where do I find the driver?
- 17 17. Which manual is the correct one to download for my Omni Reader?
- 18 18. Why does the Omni not read the Code 39 barcode that I generated by myself?