FAQ: 2DScan FX100

Q: Where can I find and download the user manual?

Downloaded the user manual from our website

Q: How do I get rid of the "*" on both sides of the Code 39 barcode data output?



A: To disable the output of the "*" for Code 39, scan the following barcode on Page 69 of the manual:

  1. Code Programming ON

  2. Transmit Neither "*" under Transmit Start & Stop Character section

  3. Code Programming OFF

  4. Test read the barcode to confirm the "*" characters are gone

Q: How do I append a Tab at the end of the barcode output?



A: To append a Tab at the end of the output, scan the following barcodes:

  1. Code Programming ON (on page 126)

  2. Enable User Suffix

  3. Program User Suffix

  4. 0 (on page 137)

  5. 9 (on page 138)

  6. Save (on page 139)

  7. Code Programming OFF (on page 126)

Q: I set the scanner to the factory default, it won't output the data in a text editor now. What should I do to get it back to work?

A: Set the reader back to USB/Keyboard interface by scanning the following barcode on page 30:

  1. Code Programming ON

  2. Select USB HID-KBW

  3. Code Programming OFF

Q: How do I set the scanner to skip the "*" for Code 39 output (*12345 -> 12345"), and insert Space at the very end as a terminator (12345space12345)?

A: Scan the following setup barcodes in sequence:

  1. Code Programming On from any page of the manual

  2. Transmit Neither "*" (on page 69)

  3. Enable User Suffix (on page 126)

  4. "2" & "0" (on page 137)

  5. "Save" (on page 139)

  6. Code Programming Off (from any page of the manual)

Q: I am using Excel, and when I scan my barcode it skips a line after the scan. How do I make it to the next line?



Please scan the following barcodes in sequence from the manual on page 126:

  1. Scan the Code Programming ON

  2. Enable Stop Suffix

  3. Program Stop Suffix

  4. Program Ox0D as Stop Suffix

  5. Code Programming Off

Q: How do I reset the IDBA-6641LRB USB keyboard emulation interface scanner default?

A. Scan the following barcodes in sequence from the manual on page 23 to reset the scanner to the factory default first:

  1. Code Programming ON

  2. Load All Factory Default

  3. Code Programming OFF

B. Scan the following barcode in sequence on page 30 to set it to USB/Keyboard emulation interface:

  1. Code Programming ON

  2. Select USB HID-KBW

  3. Code Programming OFF

Q: How do I set the scanner to add an Enter at the end of the output for a USB/KBW interface scanner with Firmware Ver: 3.06.038?

A. Please scan the following barcodes:

  1. Code Programming ON (on page 127)

  2. Enable Terminal

  3. Program 0x0D as Terminal

  4. Code Programming OFF (on page 127)



Note: Units with Firmware Ver: 3.06.026 add Enter by default.

See also: