How do I Check and Activate Encryption on the Augusta?

AnswerencryApA

Answer:

Before you begin, have the following items prepared:

• Our publicly available Universal SDK Demo Application: dotNET SDK Demo (aka uDemo) - Downloaded from the Universal Library for Visual Studio - Home - Knowledge Base - Confluence (atlassian.net)

• An Augusta device that has been already key injected, or Remote Key Injected (consult the linked guide)

• For best results, ensure that no other devices are plugged in (except the device you plan to activate Encryption on)

1.  Plug in the device, and ensure that the device is powered on. A blue LED light should light up, indicating the device is on and receiving power.

2. Wait for the drivers to install. This may take a while. Upon success, the user should hear a quick beeping noise from the machine. This indicates the device is now properly installed.

3. Open the Universal SDK Demo (uDemo), and verify that the device name is correct in the Connection window (# 1 in the screenshot below) 

4. Under the COMMANDS window, navigate to the Config, click the "+" sign to expand the command tree,  and double-click "Get Enc. Control" or single click then click the Execute Command button (shown below). This will get the current encryption settings on the device. 
   
   

   Open

   

5. If neither option is checked or "On" in the Results window, you can enable either one or both as needed with the steps shown in the screenshot below: 

   Open

   

6. Repeat the Get Encryption Control to verify the encryption is properly enabled for MSR, ICC, or both as needed