Bluetooth Test with Enzytek BLE SPS_C Test Jig

This is Blue tooth Test Jig & Test Topology.

See following (Fig 01) and remind you...

Fig Info

01


(#)Comment
(1)GND
(2)PIO11 Pin, to short with (1)
(3)Jig's COM Port Side to Host / PC
(4)

Jig's Main Board Side Power Supply from USB Port

of Host / PC or from USB Adapter.

(5)

if (4) is Power ready, this LED indicates the Jig

Power ON

02

(#)Comment
(1)

Enzytek BLE Golden SPS , as Test Jig

(2)DUT - BTPay Mini, USB Connected, To Host / PC
(3)USB Power Supply (to USB Port or Adapter)
(4)COM Port, To Host / PC
(5)(Wake Up Button) of DUT
(6)

BLE Indicator of DUT.

LED Blinking Behavior as the following

  1. Long Period ON/ Short OFF = Scanning
  2. Short Period ON/ Long OFF = Connected

Note 01: NO PIO11 Pin is required since New Data Mode Command "^^^<CR>" for disconnection is ready.

Note 02: Tx / Rx Pairing depending on (4) RS-232 Cable Tx / Rx pins has been exchanged.

03

Test Environment, Concept Fig.


Ref Link : Blue tooth Test Info


(FIg 01)



Step-by-step guide

  1. The DUT (BTPay Mini) must keep in USB connection to PC.
  2. To plug (4) to another PC usb interface to provide Enzytek BLE SPS_C Jig Power,

  3. To check (5) indicator On,RED
  4. To connect (3) to PC COM Port for TS performing AT Commands to the Jig.
  5. PIO 11 short : Short (1) and (2) immediately then OFF the link  while TS asking to short "PIO 11" Pin.
  6. How to investigate DUT's blue tooth address ?


  • Warn that PIO 11 PIN can't contact to any power source path or pins which such invalid shorting it will damage the Jig.
  • AT Commands for Enzytek Bluetooth module - Enzytek-AT_Cmds_BLE_Golden_SPS .msg

Related articles


BT Test Android App

VersionDateComment

 

  • For New BLE Chipset since Enzytek OOB the elder one.
  • User Guide


Bluetooth Fixture/Jig Test

ItemDateComment

Example 01

Jig Test Log

 

See the attachment