Page Comparison

...

1. Launch the MagSwipe Configuration Software with the known working reader connected to a USB port of the computer directly
2. Click the "Change Advanced Reader Settings" on the left (step #1) and then follow the numbered sequence in the screenshot below to get the working reader's settings read into this software
   Image RemovedImage Added
3. You should see this confirmation pops  up:  
   Image RemovedImage Added
4. Click the OK button. Disconnect the working reader first and then connect the new reader to the USB port 
5. Click on the Clone to MSR button (step # 6) shown in the screenshot below:
   Image RemovedImage Added
6. You should see this confirmation pops up:

            Image RemovedImage Added

Test read a card in Notepad to confirm the output looks exactly the same as the working reader's. And then do a transaction in your app to confirm it works.

...

...