How to set up BT parameters
...
Setting Up BT Parameters
Follow the steps below to set BT parameters using the Set Bluetooth Parameters (77-81 cmd) command:
- Name: VP3600-TL //
...
- 56 50 33 36 30 30 2D 54 4C 00 // Note: Command must end with 0x00.
- Old Password: 123456 //
...
- 31 32 33 34 35 36
- New password: 654321 //
...
- 36 35 34 33 32 31
5669564F746563683200778100165650333630302d544C0031323334353636353433323126FE
14:32:11.970: IN: 5669564f7465636832007700000077bf
| Note |
|---|
For security purposes, the firmware is unable to communicate with your device when using the Default password of 123456. Therefore, the change the password to something different to allow for full access. |
(NOTE: For security purposes, the firmware will not be able to communicate with your device when using the Default password of "123456". Therefore, the password should be changed to something different to allow full access)
I attached See the two video clips that demonstrate how to pair below for a demonstration on pairing a VP3600 reader to IDTech ID TECH's iOS and Android demo appapps.
iOS Demo App
iOS demo app:
...
- Reset the device name and password.
...
- Tap Search BLE Scan
...
- to search
...
- for the nearby reader
...
- named VP3600-TL
...
- .
...
- Enter device name
...
- VP3600-TL
...
- in the upper right corner
...
- and
...
- tap Search BLE Scan
...
- again.
...
- Repeat
...
- step three several times until
...
- prompted for a password.
...
- Enter
...
- 654321
...
- and wait for
...
- the phone and reader to connect. The connection is complete when the demo app displays Connected in the middle of the window
...
- .
- Tap Get Firmware to verify the connection.
Android Demo App
Vp3600_Android.movAndroid demo app:
- Reset the device name and password.
- Launch the demo app and enter the BTLE device name.
- If the phone and reader are not connected, we shall pairing pair the device in setting - Settings > Bluetooth.
- Select reader name "VP3600-TL" for the reader and enter password "654321" 654321 for the password,
- Run the Android demo app and enter reader name "VP3600-TL " // expecting to see "connected" in the demo appSend get firmware for the reader name. The connection is complete when the demo app displays Connected in the middle of the window.
- Send Get Firmware to verify the connection.