Versions Compared

Old Version 1

changes.mady.by.user IT-ADMIN G (Deactivated)

Saved on

compared with

New Version 2

changes.mady.by.user Yan Mu

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Image Removed

...

  1. Launch the uDemo with the reader connect to one of the USB ports on a PC and confirm it's recognized by the uDemo in the Connection pane
  2. Double click the "KB Mode status" under the Device tree and confirm in the Results pane that it's either in the "HID mode" or the "QuickChip KB mode"
  3. Click the Send Data Command under the Device tree and select the "Wrap NGA" option and then enter the "78 53 01 12 04 01 00 00 00" command in the Hex Data pane
  4. Click the "Execute Command" button below the COMMANDS pane and verify the Response HEX is "06" in the Results pane

The screenshot below shows the entire procedure with the device is in the QuickChip KB mode:

Image Added

Note:

To re-enable the beeper on the reader, send the "78 53 01 12 04 00 00 00 00" command with the same steps.