This is Blue tooth Test Jig & Test Topology.
See following (Fig 01) and remind you...
(FIg 01)
Part # | Comment |
---|---|
(1) | GND Pin |
(2) | PIO 11 Pin |
(3) | COM Port , to PC |
(4) | USB, Power Supply ONLY |
(5) |
Step-by-step guide
- The DUT (BTPay Mini) must keep in USB connection to PC.
To plug (4) to another PC usb interface to provide Enzytek BLE SPS_C Jig Power,
- To check (5) indicator On,RED
- To connect (3) to PC COM Port for TS performing AT Commands to the Jig.
- PIO 11 short : Link (1) to (2) immediately will make it while TS asking to short "PIO 11" Pin.
- How to investigate DUT's blue tooth address ?
- Warn that PIO 11 PIN can't contact to any power source path or pins to damage the Jig.
Related articles