Step-by-step guide

Launch the MagSwipe Configuration Software with the known working reader connected to a USB port of the computer directly
Click the "Change Advanced Reader Settings" on the left (step #1) and then follow the numbered sequence in the screenshot below to get the working reader's settings read into this software
You should see this confirmation pops up:
Click the OK button. Disconnect the working reader first and then connect the new reader to the USB port
Click on the Clone to MSR button (step # 6) shown in the screenshot below:
You should see this confirmation pops up:

Test read a card in Notepad to confirm the output looks exactly the same as the working reader's. And then do a transaction in your app to confirm it works.

This works with all the IDTECH USB/HID, USBKB & RS232 interface card readers that this Configuration software supports. (e.g. SecureMag, Easy Mag, SecureHead, etc.)

Related articles

Filter by label

There are no items with the selected labels at this time.

Browser not supported