Bluetooth Test with Enzytek BLE SPS_C Test Jig

This is Blue tooth Test Jig & Test Topology.

See following (Fig 01) and remind you...

Fig

Info

01

	Comment
(1)	GND
(2)	PIO11 Pin, to short with (1)
(3)	Jig's COM Port Side to Host / PC
(4)	Jig's Main Board Side Power Supply from USB Port of Host / PC or from USB Adapter.
(5)	if (4) is Power ready, this LED indicates the Jig Power ON

02

(FIg 01)

Step-by-step guide

The DUT (BTPay Mini) must keep in USB connection to PC.
To plug (4) to another PC usb interface to provide Enzytek BLE SPS_C Jig Power,
To check (5) indicator On,RED
To connect (3) to PC COM Port for TS performing AT Commands to the Jig.
PIO 11 short : Short (1) and (2) immediately then OFF the link while TS asking to short "PIO 11" Pin.
How to investigate DUT's blue tooth address ?

Warn that PIO 11 PIN can't contact to any power source path or pins which such invalid shorting it will damage the Jig.