After you download the ipa file that comes with our SDK package to your device. Here are steps for you to make the reader connected to your iPad/iPhone.
- Push the side power button to turn on the reader. (Note: to keep the reader in the pairing mode without entering into idle, you can connect your VP3300 BLE reader to PC just making sure the reader is in full power modesettings a power source (but not a PC)
- On the Apple device>Settings -> Bluetooth -> ON> ON
- run Run the VP3300 demo app. if it shows an "Untrusted Enterprise Developer" message, go 4. otherwise, go 6
- settings -> General -> Device Management -> International Technologies -> select "Trust International Technologies ..." -> "Trust"
- run the demo app again.
- "Search for BLE Name".... and and get the device name after the BLE DEVICE FOUND:
- replace Replace the "IDTECH-BTpay Mini or Enzytek SPS_S" on the top right side of the Demo with the device name you found. search for BLE again...found. The device name, by default, is "VP3300-xxxxx" where the "xxxxx" is the last 5 digits of the reader's serial number printed on the unit label located on the bottom of the unit.
- Tap the "Search for BLE Name" again and the blue colored connection status bar in the middle of the Demo will show "Connected"
- Tap the "Get Firmware Ver." or the "Get Serial #" to verify the information received in the data window below the blue bar.
- To go to the other Demo functions, swipe from the right to left on the top half of the Demo