| Table of Contents |
|---|
1. How do I find out the type of insert unit that I have by model number?
...
2. Which manual should I download for the insert unit that I have?
Find out from model # (see above) which series (Spectrum I, II, or III) the reader belongs to and what interface type it is, if it is a smart card only, magnetic stripe only or a Combo unit. Then locate the correct manual accordingly from our website for downloading. (Contact ID TECH if the item is password protected or if you are not sure which one is the correct one for the model that you have).
3. I have a Model: IDT-833x-Txx-1xx0x-xx keyboard wedge type insert reader which outputs the card data with messages such as media detected, card seated, no data, card removed, etc., how do I get rid of these notification messages?
...
Since your unit is a Spectrum III Mag Only insert reader, you can program it through the MOIR Configuration software (Link here to the software on our website) to disable the unwanted notifications. (See screenshots below) following the steps below:
connect the insert reader to the host port based on the interface type (power up the reader through an external power adaptor if needed)
Run the MOIR Configuration software
Click the Select Reader Interface
Select the interface by clicking on the Circle below the Connector pictures on the screen that matches the one that you have, then click the Continue button
Click on the Change Basic Reader Settings button,
Click on the Read Option tab to get into the Options window, un-check the notifications that you do not need, and then click the Send to MSR button to program the reader. Wait until the configure successful notification pops up, then exit from the software
Verify the reader's output in a text editor for USB/keyboard emulation unit or Hyper Terminal for RS232, USB/CDC interface unit
See also:
| Filter by label (Content by label) | ||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|
|