Versions Compared

Version Old Version 9 New Version 10
Changes made by

Chris Barton

Chris Barton

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

After completing the process, users can re-load their application data.


Note

Before You Begin

Before you begin, make sure you have done the following:

  1. Contact your ID TECH representative to receive the v1.05 and v1.10 VP3300 firmware updates. Download the ZIP files and extract them to your computer.
  2. Download and install the latest USDK Demo app from the ID TECH Knowledge Base (if you cannot access the link, please contact support).
  3. Make sure the target VP3300 device is in USB-HID mode.

Updating VP3300 Firmware to v1.05

The steps below describe the process for updating the VP3300 firmware via firmware to v1.05 via the Universal SDK Demo.

  1. Open the USDK Demo app from the Windows Start menu.
  2. Connect the VP3300 to your PC via USB or serial port.
  3. Open the USDK Demo app from the Windows Start menu.
    Image RemovedImage Added
  4. Under Device, select Update Device Firmware, then click Execute Command.
  5. Navigate to and select the VP3300 v1.05 firmware file you downloaded earlier and click Open.
  6. The VP3300 reboots and enters the bootloader, at which point the USDK Demo app begins updating the device.
  7. When the firmware update completes, the VP3300 reboots again and the USDK Demo app prints Firmware Update Successful in the Results

Updating VP3300 Firmware to v1.10

After updating to v1.05, repeat the steps above with the v1.10 firmware update.