...
ID TECH’s SmartPINL100 encrypting PIN pad provides a compact, rugged, secure keypad interface for POS systems in which PIN and/or manual data-entry capability are required. As such, the L100 is a natural complement to ID TECH’s Spectrum Pro insert reader. Together, the Spectrum Pro and L100 provide an EMV Level 2 chip-and-PIN solution (suitable for use in kiosks and other unattended applications), meeting ADA, ANSI, PCI, and ISO standards for PIN Entry.
80141506-001 Spectrum Pro and L100 Pairing Rev. B.pdf describes the steps that must be undertaken in order to pair a SmartPIN L100 keypad with a Spectrum Pro card reader.
...
In order to remove the SmartPIN L100 from its installation (that is, before pressure is released from the Removal Detection Pressure Points), Removal Detection must first be deactivated, or else the unit will become disabled and any passwords will be lost. The section called How to Deactivate Removal Detection describes the steps that must be taken to make the unit safe for removal.
| Info |
|---|
At this point, if you check the LED on the back of the L100 you should see a steady (not blicking) green light. |
4 Pairing (High Level Overview)
| Info |
|---|
<GM - 2/27/2018 3:08:31 PM> I used the command 76 38 successfully (uncheck MAC data) |
As long as the Spectrum Pro and L100 have each been injected with a Pairing Key, pairing the units is straightforward, as it merely requires sending Spectrum Pro a specific firmware command (76 46 38 00 00), which you can easily do with the Universal Demo's "Send Data Command" facility. (Be sure to check the "Wrap as NGA" checkbox when sending a raw command.)
...
020500764625000015E103.) This produces 6 bytes of flag data in return. (See discussion below. For a full discussion of the Poll Reader command, see the Spectrum Pro Low Level API Command Guide, available from
https://idtechproducts.atlassian.idtechproducts.comnet/confluencewiki/display/KB/Downloads+-+Home.)
- Confirm that the command was successful (i.e., it returns a response containing ACK, or 0x06).
- Examine the data bytes that come back.
...
The full command string (with protocol wrapper) for entering pass-through mode should look like 02060072462001000114DA03. The final 01, before the last three bytes (14 DA 03), means to turn pass-through mode ON. (See the Spectrum Pro Low Level API Command Guide, available from https://idtechproducts.atlassian.idtechproducts.comnet/confluencewiki/display/KB/Downloads+-+Home, for details.)
Using the Universal SDK Demo app, send the Get Status for Key command string,
...
If PIN blocks are not being received and you are sure the L100 is securely mounted and working properly, check that the green operating status light on the back of the unit (not the front bezel), near the power wiring, is illuminated. If it is not (if just the amber light is showing), readjust clamps or mountings on the front bezel to be sure the removal-detection buttons are depressed, and recheck the light. (These buttons can be tricky. Use thin shims or metal strips if necessary to make sure the buttons are down when the unit is in final position.) When the green light is showing, you can put the reader in Removal Detection Mode: Re-power the L100, and when the unit beeps, quickly enter the logon sequence (Cancel Clear Enter Blank Clear Enter), then at the prompts, enter the user passwords; then select Enable CR from the menu. You should see an Activation Success message.