Table of Contents |
---|
This is Blue tooth Test Jig & Test Topology.
See following (Fig 01) and remind you...
Fig | Info | ||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
01
|
| ||||||||||||||
02 |
Note 01: NO PIO11 Pin is required since New Data Mode Command "^^^<CR>" for disconnection is ready. Note 02: Tx / Rx Pairing depending on (4) RS-232 Cable Tx / Rx pins has been exchanged. | ||||||||||||||
03 | Test Environment, Concept Fig.
Ref Link : Blue tooth Test Info |
(FIg 01)
Step-by-step guide
- The DUT (BTPay Mini) must keep in USB connection to PC.
To plug (4) to another PC usb interface to provide Enzytek BLE SPS_C Jig Power,
- To check (5) indicator On,RED
- To connect (3) to PC COM Port for TS performing AT Commands to the Jig.
- PIO 11 short : Short (1) and (2) immediately then OFF the link while TS asking to short "PIO 11" Pin.
- How to investigate DUT's blue tooth address ?
Info |
---|
|
Related articles
Filter by label (Content by label) | ||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
Page Properties | ||
---|---|---|
| ||
|