...
See following (Fig 01) and remind you...
(FIg 01)
| Part # | Comment |
|---|---|
| (1) | GND Pin |
| (2) | PIO 11 Pin |
| (3) | COM Port , to PC |
| (4) | USB, Power Supply ONLY |
| (5) | Power ON Indicator |
...
| Fig | Info | ||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| 01 |
| ||||||||||||||
| 02 |
Ref Link : Blue tooth Test Info |
(FIg 01)
Step-by-step guide
- The DUT (BTPay Mini) must keep in USB connection to PC.
To plug (4) to another PC usb interface to provide Enzytek BLE SPS_C Jig Power,
- To check (5) indicator On,RED
- To connect (3) to PC COM Port for TS performing AT Commands to the Jig.
- PIO 11 short : Short (1) and (2) immediately then OFF the link while TS asking to short "PIO 11" Pin.
- How to investigate DUT's blue tooth address ?
...